Transcription of Fusion Material Settings - Epilog Laser
{{id}} {{{paragraph}}}
Example: confidence
Fusion Material Settings - Epilog Laser
- 189 - Fusion Series Suggested Material Settings (CO2)APPENDIX B: Material SETTINGSF usion Series Suggested Material Settings (CO2) watt40 watt50 watt60 watt75 watt120 wattAcrylicPhoto Engraving300 DPI90s 60p90s 55p90s 50p90s 45p90s 40p90s 30pText/Clipart Engraving300 DPI90s 80p90s 75p90s 70p90s 65p90s 60p90s 55pText/Clipart Engraving600 DPI90s 75p90s 70p90s 65p90s 60p90s 55p90s 50pCutting 1/8 (3 mm)100 f5s 100p6s 100p7s 100p8s 100p10s 100p12s 100pCutting 1/4 (6 mm)100 f2s* 100p3s* 100p 1s 100p2s 100p3s 100p7s 100pCutting 3/8 ( mm)100 f2s* 100p3s* 100p 1s 100p3s 100pCutting 1/2 (13 mm)100 f1s 100pCutting Note: Adjusting the standard focus distance so it is closer to the lens by about .080 (2 mm) will produce better edge quality when cutting 1/4 (3mm) acrylic and thicker.
* The Fusion has two sets of Speed control for vector cutting applications. Checking the Speed Comp selection box in the print driver will reduce the speed setting you have selected by one half. Speed Comp is most useful for speeds of 1 to 10. Example: Cut a square at 5% speed. Then repeat the job at 5% speed and also select Speed Comp.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: