Transcription of Gear Inspection and Measurement
{{id}} {{{paragraph}}}
Example: tourism industry
Gear Inspection and Measurement
44 GEARTECHNOLOGYGear Inspectionand MeasurementRobert Moderow,ITW.,Imnois Tools, Uncolnwoodl,ItThe purpose of gear Inspection is to: Assure required accuracy and quality, Lower overall cost of manufacture by con-trolling rejects and scrap. Control machinesandmachining practicesand maintain produced accuracy as machinesand tools wear, Determine heat corrections ..Basic gear Ins-pection TermsRunout (Radial) -The total variationoftheradial distance of a geal"s teeth from its center(or bore). Runourerrors contribute to gear noise,binding. and additional stress in mating (Sectional) -A condition of radialrunount where muchof theerror occurs in dewteeth and is not evenly distributed overtheentire gear .
gear. Tooth-fa-tooth composite enol' is the variation of the center distance when the work gear is rotated through an angle of 3601N de-grees, where N is the number of teeth in the work gear. (See Fig..9.) Terms Associated With the Dual Flank …
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: