Transcription of General tolerances
{{id}} {{{paragraph}}}
Example: marketing
General tolerances
BRITISH STANDARDBS EN22768-2:1993 ISO 2768-2:1989 General tolerances Part 2: Geometrical tolerances for features without individual tolerance indicationsThe European Standard EN 22768-2:1993 has the status of aBritish StandardUDC Copy: London South Bank University, London South Bank University, Wed Mar 15 03:46:41 GMT 2006, Uncontrolled Copy, (c) BSIBSEN22768-2:1993 This British Standard, having been prepared under the direction of the Machine, Engineers and Hand Tools Standards Policy Committee, was published under the authority of the Standards Board and comes into effect on15 July 1993 BSI 03-1999 The following BSI references relate to the work on this standard:Committee reference MTE/24 Draft for comment 87/78364 DCISBN 0 580 21934 8 Cooperating organizationsThe European Committee for Standardization (CEN), under whose supervision this European Standard was prepared, comprises the national standards organizations of the following countries:AustriaOesterreichisches NormungsinstitutBelgiumInstitut belge de normalisationDenmarkDansk StandardiseringsraadFinlandSuomen Standardisoimisliito, fran aise de normalisationGermanyDeutsches Institut f r Normung Organization for StandardizationIcelandTechnological Institute of IcelandIrelandNational Standards Authority of IrelandItal
definitions for geometrical tolerances given in ISO1101 and ISO5459 apply. 5 General geometrical tolerances (see also clause B.1) 5.1 Tolerances for single features 5.1.1 Straightness and flatness The general tolerances on straightness and flatness are given in Table 1. When a tolerance is selected from Table 1, it shall be based, in the case of
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: