Transcription of General tolerances for Iinearand angular DIN …
{{id}} {{{paragraph}}}
/ - UDC 621 ..753 .1 : 621 .7 : 621 .9 : 744 .43 DEUTSCHE NORM April 1991. General tolerances for Iinearand angular DIN. dimensions and geometrical= . tolerances (not to be used for .new destgns) .'-j' ;,, 7168. Allgemeintoleranzen ; Langen- and Winkelma8e,Form and=Lage& ' Supersedes May 1981. (nicht fur Neukonstruktionen) '..'7' 1 edition of DIN 7168. Part 1 and July 1986. This standard is not to be used for new designs . General tolerances for these are now covered by ISO 2768 Parts 1 and 2 . See also clause 1 and the Explanatory notes . In keeping with current practice in standards published by the International Organization for Standardization (ISO), a comma has been used throughout as the decimal marker . m m- 1 Scope General tolerances as specified in this standard apply for : m a) linear dimensions, such as external sizes, internal 01 This standard is intended to ensure that all drawings sizes, step sizes, diameters, clearances (cf.
Page 2 DIN 7168 3 General tolerances for linear and angular dimensions 3.1 Linear dimensions Table 1. Permissible deviations for linear dimensions, except for external radii and chamfer heights
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}