Guide To Electrical Safety Testing - Hipot

To ElectricalSafety TestingElectrical Safety Compliance Simplified GENERAL INFORMATIONWhy Test?2 There are four main reasons why you should Safety test your products prior to shipment1. SafetyEnsure that the product is not going to pose a hazard to the end QualityDetect workmanship defects and prevent faulty components from being Cost ControlIdentify production problems before a product is shipped, preventing costly LiabilityPrevent product liability suits because the responsibility of performing Electrical Safety tests ultimately rests on the manufacturerNRTL standards dictate that Electrical products incorporate two lines of defense to protect the user from Electrical shockInsulationSafety Grounds Separates power lines from low voltage circuits. Separates power lines from isolated power supplies. Isolates input power from the chassis or case of an Electrical device. Allow dangerous fault currents to return to system ground.

Safety Interlock. This protects you from touching the DUT while a test is in progress. If the enclosure door is opened, the tester’s high voltage is immediately disabled. Gives an indication as to the status of the testing area. A green light indicates the tester is not outputting high voltage and the test area is safe. A red light indicates

Loading..

Tags:

  Safety, Doors

Information

Related search queries