Transcription of H-Bridge Gate Driver IC - NXP
{{id}} {{{paragraph}}}
Example: marketing
H-Bridge Gate Driver IC - NXP
MC33883H- bridge gate Driver ICRev. 27 April 2020 Data sheet: technical data SO20 1 General descriptionThe 33883 is an H-Bridge gate Driver (also known as a full- bridge pre- Driver ) IC withintegrated charge pump and independent high and low side gate Driver channels. Thegate Driver channels are independently controlled by four separate input pins, thusallowing the device to be optionally configured as two independent high side gate driversand two independent low side gate drivers . The low side channels are referenced toground. The high side channels are gate Driver outputs can source and sink up to A peak current pulses, permittinglarge gate -charge MOSFETs to be driven and/or high pulse- width modulation (PWM)frequencies to be utilized.
gate driver channels are independently controlled by four separate input pins, thus ... High-Side Source Current from CP_OUT in Switch ON State IS 250 mA High-Side Gate Voltage VGATE_HS –0.3 to 65 V ... VCC2 can sustain load dump pulse of 40 V, 400 ms, 2.0 Ω. [2] In case of high current (SRC_HS >100 mA) and high voltage (>20 V) between GATE ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: