Transcription of HELIX® SERIES Installation Guide
{{id}} {{{paragraph}}}
Example: biology
HELIX® SERIES Installation Guide
1532405-6_AHELIX SERIES CONTROL HEAD Installation Guide Follow the instructions in this Installation Guide to gimbal mount the control : Your gimbal bracket may not look exactly like the gimbal bracket shown in the illustrations, but it will mount in exactly the same PreparationRead the instructions in this transducer Guide completely to understand the mounting guidelines before starting the our Web site at for additional information and resources for transducer installations. Also, visit for informational : In addition to the hardware supplied with your control head, you will need a powered hand drill and various drill bits, Phillips head screwdriver, flat head screwdriver, pencil, safety glasses and dust mask, marine-grade silicone sealant, dielectric grease (optional), extension cables (optional), Ethernet cables (optional), and accessory cables (optional).
HELIX SERIES CONTROL HEAD Installation Guide 5324056 Δ Fuse Panel or Battery: The control head power cable can be connected to the electrical system of the boat at the fuse panel (usually located near the console), or directly to the battery. In order to minimize the potential for interference with other marine electronics, a separate power
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: