74HC541; 74HCT541 Octal buffer/line driver; 3-state

1. General description The 74HC541; 74HCT541 is an octal non-inverting buffer/line driver with 3-state outputs. The device features two output enables (OE1 and OE2).

  Drivers, Line, Buffer, Lacto, Octal buffer line driver, Buffer line driver

MMBT3904 NPN switching transistor - Nexperia

DATA SHEET Product data sheet Supersedes data of 2002 Oct 04 2004 Feb 03 DISCRETE SEMICONDUCTORS MMBT3904 NPN switching transistor …

  Switching, Transistor, Mmbt3904, Mmbt3904 npn switching transistor

BZT52H series Single Zener diodes in a SOD123F …

1. Product profile 1.1 General description General-purpose Zener diodes in a SOD123F small and flat lead Surface-Mounted Device (SMD) plastic package.

  Diode, Zener, Zener diodes in a sod123f, Sod123f

N-channel 60 V, 4.6 mΩ - Nexperia

1. Product profile 1.1 General description Standard level N-channel MOSFET in a TO-220 package qualified to 175 °C. This product is designed and qualified for use in a wide range of industrial, communications and

  Channel, N channel 60 v, N channel

PDTB113ZT PNP 500 mA, 50 V resistor-equipped transistor ...

1. Product profile 1.1 General description 500 mA PNP Resistor-Equipped Transistor (RET) in a small SOT23 (TO-236AB) Surface-Mounted Device (SMD) plastic package.

  Surfaces, Transistor, Resistor, Equipped, Resistor equipped transistor

74HC4017; 74HCT4017 Johnson decade counter with 10 …

The 74HC4017; 74HCT4017 is a 5-stage Johnson decade counter with 10 decoded outputs (Q0 to Q9), an output from the most significant flip-flop (Q5-9), two clock inputs (CP0 and CP1) and an overriding asynchronous master reset input (MR).

  With, Decade, Output, Johnson, Counter, Decoded, Johnson decade counter with 10, Johnson decade counter with 10 decoded outputs

AEC-Q101 qualified • 1 kV ESD protected 3. Applications ...

PMV130ENEA 40 V, N-channel Trench MOSFET 5 July 2018 Product data sheet 1. General description ... • 1 kV ESD protected • AEC-Q101 qualified 3. Applications • Relay driver • High-speed line driver ... Fig. 15.Gate charge waveform definitions aaa-011953 VSD (V) 0 0.4 0.8 1.2 2 1 3 4 IS (A) 0 Tj = 150 °C

  Protected, Kv esd protected, Pmv130enea

PMDT290UCE 20 / 20 V, 800 / 550 mA N/P-channel Trench …

PMDT290UCE All information provided in this document is subject to legal disclaimers. 2 J 0 8;*+ Product data sheet Rev. 1 — 6 October 2011 2 of 20

PMDT290UNE 20 V, 800 mA dual N-channel Trench MOSFET

20 V, 800 mA dual N-channel Trench MOSFET Rev. 1 — 13 September 2011 Product data sheet Symbol Parameter Conditions Min Typ Max Unit ... (j-sp) thermal resistance from junction to solder point--115K/W Per device Rth(j-a) thermal resistance from junction to ambient in free air [1] - - 250 K/W.

PSSI2021SAY Constant current source in SOT353 package

LED driver Figure 5 shows a typical application circuit for an LED driver. The constant current ensures a constant LED brightness. Switching the current ON/OFF The output can be switched ON and OFF by connecting a resistor-equipped transistor (RET, e.g. PDTC124XU) as shown in Figure 6.

  Constant, Drivers, Current, Led driver, Constant current, Constant led

NI PXIe/PCIe-6535/6536/6537 and NI PCIe …

2.5 V, 3.3 V (5 V TTL compatible) — Acquisition voltage levels Low Voltage Thresholds Maximum High Voltage Thresholds Minimum Warranted. Production tested for data 2.5 V 0.75 V 1.75 V channels. 3.3 V 1.00 V 2.30 V 5.0 V 1.00 V 2.30 V Input impedance High-impedance (50 kΩ to ground) — Input protection-1 V to +6 V Diode clamps in the design ...

  Compatible, Ttl compatible

USB to serial chip CH340 - SparkFun Electronics

Software compatible with CH341, using drive of CH341 directly. Support 5V and 3.3V source voltage. Supply SSOP-20 package without lead, compatible with RoHS. Computer ... changes TTL serial interface to RS232 serial interface through level convert circuit U8. Endpoint P11 is DB9 needle, the pin and its function is the same as ...

  Compatible

P82B715 I2C-bus extender - NXP

fully compatible with all logic signal drivers, including TTL. The P82B715 cannot modify the bus logic signal voltage levels but it contains internal diodes connected between Lx/Sx and VCC that will conduct and limit the logic signal swing if the applied logic levels would have exceeded the supply voltage by more than 0.7 V.

  Compatible

MCP23016 16-Bit I2C I/O Expander - Microchip Technology

Dec 08, 2006 · GP0.2 23 20 I/O TTL D2 digital input/output for GP0 GP0.3 24 21 I/O TTL D3 digital input/output for GP0 GP0.4 25 22 I/O TTL D4 digital input/output for GP0 GP0.5 26 23 I/O TTL D5 digital input/output for GP0 GP0.6 27 24 I/O TTL D6 digital input/output for GP0 GP0.7 28 25 I/O TTL D7 digital input/output for GP0 SCL 14 11 I ST Serial clock input

8-bit Microcontroller with 8K Bytes In-System Programmable ...

Port 0 is an 8-bit open drain bidirectional I/O port. As an output port, each pin can sink eight TTL inputs. When 1s are written to port 0 pins, the pins can be used as high-impedance inputs. Port 0 can also be configured to be the multiplexed low-order address/data bus during accesses to external program and data memory.

Application Examples - Vishay Intertechnology

TTL ACTIVE LEVEL HIGH (7400 SERIES) TTL ACTIVE LEVEL LOW (7400 SERIES) There are obviously many other ways to drive the device with logic signals, but a majority can be met with the above circuits. All provide 10 mA into the LED, giving 2 mA minimum out of the phototransis tor. The 1 V diode knee and

  Vishay, Vishay intertechnology, Intertechnology