HOME-FLEX® Fitting Assembly

HOME-FLEX CSST Fitting Assembly Step 1: Cut pipe to length Step 2: Remove pipe jacket Step 3: Place flange nut Using a stainless steel tube cutter, cut Using a utility knife, strip the yellow Slide the flange nut over the tubing the HOME-FLEX tubing to the desired tubing jacket back 2 valleys from the with the threaded end pointing length, leaving 1" for placement of the end of the tubing. Also remove the toward the end of the tubing, being Fitting . Cut in the valley of the tubing yellow warning label from the Fitting careful to not dislodge the o-ring and clean any burrs or jagged edges. Assembly . inside the nut*. Do not push the nut DO NOT USE A TUBE CUTTER. beyond the catch on the jacket. The flange should cover the yellow jacket. Step 4: Place retainer ring Step 5: Install Fitting Step 6: Attach flange nut Pulling with two pliers, stretch the Make sure that the non-metallic Place the HOME-FLEX flange nut brass retainer ring open so that it gasket inside the Fitting is secure on onto the installed Fitting .

HOME-FLEX® CSST Fitting Assembly Troubleshooting Fitting Assembly and Correcting Leaks Step 1: Gradually tighten fitting until leak stops. Step 2: If leak does not stop after reaching maximum torque, stop, open the assembly and check: a. Proper fitting assembly. Make …

Loading..

Tags:

  Fitting, Assembly, Tighten, Fitting assembly, Tighten fitting

Information

Related search queries