Transcription of HOSE BARB BRASS FITTINGS Hose Barb Fittings
{{id}} {{{paragraph}}}
HOSE BARB BRASS FITTINGS . Hose Barb FITTINGS BRASS . For Lead Free AB1953 Compliant FITTINGS see pages 166-175. Temperature and Working Pressure Ranges From -400F to + 1600F at 150 PSI maximum. Tolerance +/- .02 on all dimensions. Dimension Data can change 2- Slide clamp on hose. without notice. Please call us when dimensions are criti- 3- Lubricate hose. Push hose on fitting until hose cal. bottoms against stop ring or hex. 4- Position hose clamp as shown below and secure Material with a screwdriver or wrench. Maintain A . CA360 BRASS for Barstock FITTINGS . dimension noted below for proper clamp position- CA377 BRASS for Forged FITTINGS . ing. Note: These FITTINGS are intended for use with hose clamp, similar type clamp or a crimped ferrule. Assembly Instructions 1- Cut hose cleanly and squarely to length.
Note: These fittings are intended for use with hose clamp, similar type clamp or a crimped ferrule. • Assembly Instructions 1- Cut hose cleanly and squarely to length. 2- Slide clamp on hose. 3-Lubricate hose. Push hose on fitting until hose bottoms against stop ring or hex. 4- Position hose clamp as shown below and secure with a screwdriver ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}