Transcription of How to design an antenna for dynamic NFC tags
{{id}} {{{paragraph}}}
Example: air traffic controller
How to design an antenna for dynamic NFC tags
March 2019AN2972 Rev 91/261AN2972 Application noteHow to design an antenna for dynamic NFC tags IntroductionThe dynamic NFC (near field communication) tag devices manufactured by ST feature an EEPROM that can be accessed either through a low-power I2C interface or an RF contactless interface operating at MHz. Both short-range (ISO/IEC 14443 Type A) and long-range (ISO/IEC 15693) standards are 1. dynamic NFC tagsDynamic NFC tag can be used in many applications, with the requirement that the processor features an I2C application note intends to: explain the basic principle of passive RFID describe the basics of a MHz inductive antenna design provide guidelines for a successful integration, from design to b l e 1 lists the products concerned by this application note. Table 1. Applicable productsTypeApplicable productsDynamic NFC tagsST25DV-I2C, ST25DV-PWM, M24LR and M24SR series dynamics NFC Tags, & LQWHUIDFH 5) LQWHUIDFH((3520DL Rev 9 Contents1 Operating mode.)
• how well the tag antenna is tuned, close to the reader's carrier frequency (13.56 MHz) • the distance between the reader and the tag antenna board • the dimensions of the reader antenna and of the tag antenna board • the reader power • the tag antenna orientation related to the reader antenna. Figure 3.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: