Transcription of HOW-TO HOW-TO LAY HARDBOARD OR PLYWOOD FLOOR …
{{id}} {{{paragraph}}}
Example: quiz answers
HOW-TO HOW-TO LAY HARDBOARD OR PLYWOOD FLOOR …
HOW - TO1 Most FLOOR coverings, if laid over uneven wooden floors, will wear unevenly and look unsightly. Theanswer is to cover the old boards with HARDBOARD or PLYWOOD before laying expensive - TOHOW-TO LAY HARDBOARD OR PLYWOOD FLOOR OVERLAY HARDBOARD or PLYWOOD , see Before You Start Ring nails, 20mm for HARDBOARD , and 6mm for PLYWOOD Flooring staples, 15mm for board and 21mm for 6mm board No. 6 screws, 25mm x countersunk zinc-plated for 12mm PLYWOOD No. 8 screws, 38mm x for fixing floorboards Solvent-based panel adhesive Wood filler, 2 parts polyester Red insulating tape Aluminium oxide abrasive discs for random orbit sander, 40-80 grit Abrasive paper, coarse Brown wrapping paper Electric drill plus HSS bits, countersink bit and flat bits OR Drillmate and flat bits Electric jigsaw or coping saw Electric planer Random orbit sander Frame gun for adhesive Flooring staple gun (spot nailer), which can be hired Nail punch Electric screwdriver Handsaw, fine tooth, hard point Claw hammer, 16 or 20ozMATERIALSTOOLS Pincers Chisels, and 6mm Cra
HOW-TO 3 DOORS With the door closed, place a piece of the plywood or hardboard and its planned covering against the door. If the door won’t open, mark it with a pencil for a 3mm clearance(F1).Remove the door and take off the waste with a
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: