http://www.workriteergo.com/documentation/instructions/Programmable_Control_User_Guide_1500220.pdf

PROGRAMMABLE CONTROLUser TIME WORKCENTER OPERATIONIf your workcenter has not been Initialized the code E0 1 appears when you press any of the control YOUR WORKCENTER1. Press and hold button until the workcenter moves all the way down and the display reads " then release the Press and hold button AGAIN until the workcenter moves down then up slightly. Your Sierra SEHX or Fundamentals FDEX workcenters are now ready to use. For Sierra HXL the readout needs to be changed to read " using the Adjusting Display Height step THE DISPLAY HEIGHT FOR SIERRA HXL1. Press button to fully lower the workcenter and the display reads ".2. Press and hold both the and buttons simultaneously. Three dashes will appear ( ). Wait for the numeric display to Press button until the display reads ". You have about one second to adjust the height. 4. The display will flash when the change is PROGRAMMABLE CONTROL INSTRUCTIONSM emory ButtonsHeight ControlSet ButtonDisplayPlease read the instruction completely before you will time-out if not completed within 5 seconds.

We would like to show you a description here but the site won’t allow us.

Loading..

Information

Related search queries