Transcription of HUB CITY WORM GEAR DRIVES INSTRUCTIONS …
{{id}} {{{paragraph}}}
CALL:(605)225-0360 FAX:(605)225-0567 AHUB city worm gear DRIVES INSTRUCTIONST hese general maintenance INSTRUCTIONS cover Series 130 through Series 80 worm gear Reducers. Your reducer may be slightly different than thereducers shown in the figures below, and to the right, but these generalinstructions will still is advisable to periodically inspect your Speed Reducer for any signs ofimpending service. Spare or replacement parts can often be ordered andobtained before disassembly is necessary, thus minimizing machinedown-time. The following symptoms can be inspected visually withoutdisassembly and may, in some cases, indicate extensive LEAKING FROM SEALS indicates that shaft and/or seals are worn andneed replacing. Keep dirt and foreign particles off shafts in the area of theseals to minimize LEAKING FROM INPUT OR OUTPUT CAPS, CAP SCREWS OR PIPEPLUGS might be corrected by retightening or removal and recoating withLoctite or pipe sealant as required before tightening.
A CALL: (605) 225-0360 FAX: (605) 225-0567 HUB CITY WORM GEAR DRIVES INSTRUCTIONS These general maintenance instructions cover Series 130 through Series 80 Worm Gear Reducers.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}