Transcription of IADC Dull Grading - Halliburton
{{id}} {{{paragraph}}}
Example: dental hygienist
IADC Dull Grading - Halliburton
Drill Bits Fixed Cutter IADC dull Grading Cutting Structure Inner Rows Outer Rows dull Char. Location Bearings/Seals Gauge Other dull Char. Reason Pulled 1 2 3 4 X 6 7 8. Inner Area Outer Area 1 Inner Cutting Structure 4 Location 2/3 Radius 1/3 Radius 2 Outer Cutting Structure A - All Areas C - Cone A measure of lost, worn and/or G - Gauge broken cutting structure. N - Nose HAL9086. Linear Scale: 0-8. S - Shoulder 0 - No lost, worn and/or broken T - Taper cutting structure 5 X. 8 - All of cutting structure lost, 6 Gauge worn and/or broken (Measure in fractions of an inch). 3 dull Characteristics I - In Gauge BF - Bond Failure 1 - 1/16" Out of Gauge BT - Broken Cutters 2 - 1/8" Out of Gauge BU - Balled Up 4 - 1/4" Out of Gauge Gauge CR - Cored 7 Other dull Characteristics Shoulder CT - Chipped Cutters (Refer to column 3 codes). DL - Delaminated Cutters Taper Cone ER - Erosion 8 Reason Pulled or Run Terminated HAL9085.
IADC Dull Grading Inner Rows Outer Rows Dull Char. Location Bearings/Seals Gauge Other Dull Char. Reason Pulled 1 2 3 4 X 6 7 8 HAL9086 Gauge Shoulder
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
IATA Training Grading Policy, Grading, Scale, Kellgren-Lawrence Grading Scale, The new common points scale, Grading Scale for Behind the Wheel Lessons, Grain Grading and Sampling Equipment, Introduction to the Federal Wage System Job, Federal Wage System Job Grading, Introduction to the Federal Wage System Job Grading, Entry to Higher, Entry to Higher Education from 2017