Transcription of INCH STANDARD COUNTERBORE - Electroimpact
{{id}} {{{paragraph}}}
Example: bachelor of science
INCH STANDARD COUNTERBORE - Electroimpact
REV. F 06/02/2005 SCREWSCREWCAP HEADCAP HEADSOCKET CLEARANCEC'BORECLEARANCEC'BOREC' (MAX)(MAX)(CLOSE)(CLOSE)(FREE)(FREE)H'DH d'D'd'D'# # #2# # #4# # # #6# # # #8# # # #101 +/- FREECLOSECLEARANCE SHOULD BE USED UNLESS CLOSE IS REQUIREDINCH STANDARD COUNTERBOREDHdD'H'd'Printed copies of Electroimpact standards are for reference only and are not subject to revision H 06/02/2005 SCREWSCREWCAP HEADCAP HEADSOCKET CLEARANCEC'BORECLEARANCEC'BOREC' (MAX)HEIGHT (MAX)SIZEDIA. (CLOSE)DIA. (CLOSE)DIA. (FREE)DIA. (FREE)DEPTHSIZEdDHd'D'd'D'H' : " FREE SIZES " AND AND THREAD PITCHES SHOULD ALWAYS BE SPECIFIED, ARE NOT McMASTER CARR STANDARD CUTTING TOOLSBUT WHEN METRIC THREADS ARE SPECIFIED WITHOUT A PITCH, FREE SHOULD BE USED UNLESS CLOSE IS REQUIREDTHE FOLLOWING PITCHES ARE TO BE USED:TOLERANCES +/- M 2X.
wrench flats rev. d 11/1/15 metric sae nominal max. min. width max. min. width mm mm mm in in in in
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: