Transcription of INERTIA BASE Installation Instructions - vimco.biz
{{id}} {{{paragraph}}}
Example: marketing
INERTIA BASE Installation Instructions - vimco.biz
1. Lay a sheet of polyethylene on floor and place INERTIA base in its operating location with rebar located toward bottomof If anchor bolts are provided by VIMCO, verify that their locations match equipmet mounting holes. Pour concrete andlet it After concrete hardens, raise INERTIA base to install isolators under isolator mounting clips and place blocks/shims tomaintain INERTIA base at operating Install equipment on base and anchor in place using VIMCO anchor bolts or post-drill Use isolator height adjustment mechanisms to raise base of blocks/shims and Remove blocks/shims and clear debris after / Remarks :Title :Rev. 0 Drawing BASEI nternet MANAGEMENT CORPORATION5930 THOMAS ROADHOUSTON - TEXAS 77041 , USA Project :Client :Consultant :Representative.
1. Lay a sheet of polyethylene on floor and place inertia base in its operating location with rebar located toward bottom of base. 2. If anchor bolts are provided by VIMCO, verify that their locations match equipmet mounting holes.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: