Transcription of INS2153C - 6/14
{{id}} {{{paragraph}}}
Example: bankruptcy
INS2153C - 6/14
INS2153C - 6/14. Care Instructions English English To preserve the finish on the metallic parts of your Moen faucet, apply non-abrasive wax, such as car wax. Any cleaners should be rinsed off immediately. 6. Post installation - Troubleshooting Guide Problem Possible To Diagnose Remedy Cause Hot/cold reversed Lines reversed/car- Hot/cold reversed Rotate cartridge stem 180 . tridge installed upside so that the notch is facing down down towards the drain. No water/low flow One or both supplies No water/low flow Turn both water supply not on to the unit valves counterclockwise to the on position Leak or drip from Grommets not sealing Leak/drip from spout Replace cartridge spout properly Only hot/no cold Balancing spool stuck Only hot/no cold Only Replace cartridge Only cold/no hot cold/no hot Stacking (Water Choice of pipe/dis- Water comes out of spout Remove tub spout and comes out of the tance between valve and showerhead at the same flush out debris Replace showerhead dur- and showerhead less time undersized line or fittings ing tub fill mode) than 46"/multiple elbows/anything restricting flow of water exiting valve One Handle Tub/Shower Valve Trim with Handheld Showerhead Flow restriction Water comes out of spout Remove tub spout and between valve and tub and showerhead at the same flush out debris Replace spout time causing restricti
Thin Wall Installation 4-1/2" (114mm) more than 1/4" (6mm) Thick Wall Installation Plaster Ground Valve OR G B F 2 3 Secure escutcheon to wall. (Wall) D F P 1 3.1 3.2 Ensure cartridge clip is installed prior to escutcheon installation.For a thin wall installation, the wall will be "trapped" between the plaster ground and the trim. The plaster ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: