Transcription of INSPECTING AND REPLACING WIRE ROPES
{{id}} {{{paragraph}}}
Example: bachelor of science
INSPECTING AND REPLACING WIRE ROPES
MODULE NUMBER 14 OFINSTRUCTION GUIDE NUMBER 43ON-THE-JOB TRAININGFORSURFACE METAL AND NONMETAL MINESINSPECTING AND REPLACING WIRE ROPESThis module describes basic job steps, potential hazards and accidents, and recommendedsafe job procedures for INSPECTING and REPLACING wire ROPES . The term "wire rope" is used inthis module, ratherthan "cable," to avoid any possible confusion with electrical cables. Thismodule is not intended to cover wire ROPES that are used for hoisting the sand, gravel, and crushed stone industry, wire ROPES are used primarily on draglines,power shovels, and drillng equipment. Wire ROPES and wire rope slings are used on cranesand hoists of various ROPES deteriorate and will break if left in service long enough. Causes of ropedeterioration may include wear, peening (hammer action), corrosion, bending, flexing, kinking,crushing, overloading, and heat must provide for wire rope inspection and timely replacement.
safe job procedures for inspecting and replacing wire ropes. The term "wire rope" is used in this module, ratherthan "cable," to avoid any possible confusion with electrical cables. ... rope, including sheaves, drums, and rollers. 3. Wire Rope Basics The following summary provides equipment operators with basic information useful for frequent ...
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: