Installation and Setup Guide - Lennox

Installation and SetupGuideColor TouchscreenProgrammable ThermostatComfortSense 7500 (13H14)2 Table of ContentsShipping and Packing 7500 InstallationMounting SettingsMenu (Installer Settings) Part (Catalog) and Serial A. Flow B. Diagnostic C. Supported D. Installer and Packing List1 - ComfortSense 7500 touchscreen, 7-dayprogrammable thermostat and back plate2 - Mounting screws ( self-tappingscrews)2 -Wall anchors1 -Wall plate1 - Warranty certificate1 each - Homeowner and Installer GuidesNOTE - This thermostat is equipped withautomatic compressor protection to preventpotential damage due to short cycling or extendedpower outages. The short-cycle protectionprovides a 5-minute delay between heating orcooling cycles to prevent the compressor frombeing this manual before programming the ther this thermostat only as described in this man 7500 Thermostat (CatalogNo.)

Dehumidification Accessory (EDA). See figures 3 through 7. For whole home dehumidifier, refer to the installation instruction for the dehumidifier. 1. Connect wiring between thermostat, indoor unit, and outdoor unit as shown in the appropriate wiring diagram. 2. Connect the outdoor sensor (if used) to the T connections on the thermostat (wire run

Loading..

Tags:

  Home, Whole, Dehumidification, Lennox, Whole home

Information

Related search queries