Transcription of Installation Guide Communicaton Options
{{id}} {{{paragraph}}}
Installation Guide Communicaton Options Version HistoryVersion (November 2018)Editorial modifications Version (February 2018)Changed SolarEdge Logger to Non SolarEdge Logger in figure 'multiple inverters, RS485 bus, RS485-E, wired Ethernet (LAN) , non SE logger and modified procedure in SE Inverters Configuration after the 'Multiple Inverters with RS485-E connections ' image Version (November 2017)Added communication Options :RS485-XRS485 Plug-in Wi-FiCellular ConnectivitySmart Energy ZigBee Plug-in Updated configurations:Multiple Devices, RS485 Bus, Wired Ethernet (LAN) ConnectionMultiple Inverters, RS485 Bus, Non-SolarEdge LoggerMultiple Devices, RS485 Bus, ZigBee ConnectionAdded configurations:Multiple Inverters, RS485 Bus, RS485-E Bus, CCG, Meter, Non-SolarEdge LoggerMultiple Inverters, RS485 Bus, RS485-E, Wired Ethernet (LAN), Non-SolarEdge LoggerHigh Bandwidth Mode - Third Party SIM CardMultiple devices with a second RS485 port connection interface with Modbus devices Ver
Communication è RS485-X Conf è Device Type è SolarEdge Communication è RS485-X Conf è Protocol è Master Communication è RS485-X Conf è Slave Detect The master should report the correct number of slaves. If it does not, verify the connections and terminations. 3. For the meter, select the following:
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}