Transcription of INSTALLATION INSTRUCTIONS - American Standard ProSite
{{id}} {{{paragraph}}}
Example: bachelor of science
INSTALLATION INSTRUCTIONS - American Standard ProSite
Place back-up nuts on both bottom bolts, andthe top left-hand bolt the two lower back-up nuts so that frontface of nuts is flush with finished waste horn to project 5/16" fromfinished a level, adjust the top left back-up nut so thatit is in the same vertical plane as the lower left back-upnut. (If wall surface is irregular, the three back-upnuts must be positioned to allow a minimum 1/16"gap between fixture and wall surface.)NOTE: Bearing nuts and washers must be setto take full loading from the fixture allowing1/16" clearance between fixture and support manufacturer's recommendedsetting of closet outlet felt or neoprene gasket (wax ring notrecommended) on closet the fixture is installed, closet outletgasket must be compressed sufficiently toassure a gas and watertight bowl on support using cap nuts and fiberwashers with the back-up nuts and NOT APPLY TOP RIGHT FIBER WASHERAND CAP NUT UNTIL OTHER CAP NUTSHAVE BEEN FIRMLY TIGHTENED USING
Place back-up nuts on both bottom bolts, and the top left-hand bolt only. Adjust the two lower back-up nuts so that front face of nuts is flush with finished wall.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: