Transcription of Installation Instructions for E-Series 2 or 4-Panel ...
{{id}} {{{paragraph}}}
9054055 B D - 0 0 Revised 06/20/17 Thank you for choosing Andersen. Installation Instructionsfor E-Series 2 or 4-Panel Gliding and French Gliding Patio DoorsTools Needed Safety Glasses Tape Measure Caulk Gun Level Putty Knife Hammer and Nail SetSupplies Needed Shims (waterproof) Finishing Materials 2" Galvanized Roofing Nails Formable Self-adhearing Flashing Straight Self-adhearing Flashing Sealant Low Expanding Foam Interior Trim and/or Extension Jambs (as required) #10 x 2-1/2" Screws Backer Rod Screw Pack (included with door) 1-1/4 Brad Nails (for extension jambs as required) House Wrap Tape Stapler Utility Knife or Scissors Flat Blade Screwdriver Drill/Driver Phillips Screwdriver J-Roller Read guide from beginning to end before starting Installation . Read all warnings and cautions during unit Installation . Check with your local building code official to identify and confirm compliance with local building code requirements. Parts Included (1) Door* Installation Instructions viewable and downloadable at are for typical, new wood-framed wall construction with weather protection in place.
Installation Flanges on the unit alone will not properly flash and seal the window/door. Follow these instructions carefully. For questions call 1-888-888-7020.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}