Transcription of INSTALLATION INSTRUCTIONS FOR ELECTRONIC SINGLE …
{{id}} {{{paragraph}}}
Example: barber
INSTALLATION INSTRUCTIONS FOR ELECTRONIC SINGLE …
INSTALLATION INSTRUCTIONS FOR ELECTRONIC SINGLE FIRE IGNITIONPART NO. 53-50 INSTALLATION INSTRUCTIONS for street application using 1970 & later coils with 5 ohms of primary resistance. If installing in a raceapplication, you may use 3 ohm old the new advance assembly shaft lightly with oil. Put the magnetic rotor over the shaft and push it to connectwith the advance assembly weights. Make sure that the rotor rotates easily and the weights cycle back & to make sure the pin on the assembly seats in the slot for it on the engine. Install & tighten the bolt. Don t overtight-en, the rotor must rotate the standoffs to install the ignition with the plate aligned so the large power module is at either 12 o clock or 3 o clock.(this will depend on the model). the exhaust pipes, put the ignition assembly cable out through the engine case hole.
INSTALLATION INSTRUCTIONS FOR ELECTRONIC SINGLE FIRE IGNITION PART NO. 53-50 Installation instructions for street application using 1970 & later coils with 5 ohms of primary resistance.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
CDI Electronic Ignition / Stators & Charging Systems, Ignition, Capacitor Discharge Ignition, Capacitor discharge ignition electronic ignition, Ignition Catalog ENG, ElEcTRonic igniTion, Features: Contactless Ignition System Standard Analogue Electronic, Micro Digital Ignition System AKA, 644 Programmable Digital Ignition System, Zenith Carburetor Kits Rebuilt Distributors