Transcription of Installation Instructions for T2 / T3 Trim Systems
{{id}} {{{paragraph}}}
Example: air traffic controller
Installation Instructions for T2 / T3 Trim Systems
The Ray Allen Distribution Way Suite 15, Vista, CA 92081 USA Phone 760 599 4720 FAX 760 599 : Installation and use of Ray Allen Company products is the responsibility of the aircraft designer and manufacturer. Use of Ray Allen Company in any application which will exceed their capability can cause failure leading to injury or death. Page ! of !14 Installing the T2 / T3 servos Ray Allen servos can be mounted in any position, but they must be protected from water exposure. The mounting holes in the servo flange are 1/8 dia. You can carefully enlarge the diameter of these holes for 6-32 screws ( , 4 mm).CAUTION!! The output shaft is drilled for a 1/8 diameter clevis pin.
w The Ray Allen Company Inc. 1341 Distribution Way Suite 15, Vista, CA 92081 USA Phone 760 599 4720 FAX 760 599 4383 w .r a yle n comp 0618 Warning: Installation and use of Ray Allen Company products is the responsibility of the aircraft designer and manufacturer.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: