Transcription of Installation Instructions - Forward Lift
{{id}} {{{paragraph}}}
Example: tourism industry
Installation Instructions - Forward Lift
March 2020 by Vehicle Service Group. All rights reserved. CO11270LP60026IN60026 Rev. M CONDITIONSLift is not intended for outdoor useand has an operating ambient temperature range of41 -104 F (5 -40 C) Installation InstructionsCapacity 10,000 lbs. (4,536kg.)(400 Series Lift)IMPORTANTR eference ANSI/ALI ALIS, Safety Requirements for Installation and Service of Automotive Lifts before installing 1aFig. 1bJK44 1/2" (1130mm) MAXARM REACH23" (584mm) MINARM REACH38 1/2" (978mm) MINARM REACH58" (1473mm) MAXARM REACHLLACEFGHIBM3 Fig. 1c44 1/2" (1130mm) MAXARM REACH23" (584mm) MINARM REACH38 1/2" (978mm) MINARM REACH58" (1473mm) MAXARM REACHDJKLL4 NOTES:1.) ALL HEIGHT DIMENSIONS ARE WITHOUT LEVELING ) STANDARD HEIGHT LIFT ) ** ANCHORING SYSTEM TESTED TO ANSI/ALI ALCTV A POWER UNIT HEIGHT 72 1/2" (1872mm) B LIFTING HEIGHT W/ 5" EXTENSION 76 1/8" (1984mm) W/ 67 1/2" (1715mm) STROKE LIFTING HEIGHT W/ HIGH RISE CYLINDER 79 5/8" (2023mm) W/ 71" (1803mm) STROKE C MIN.
D) Pull the cable back down, Fig. 6. E) Run cable around the lower sheave, then up and out of the top of the column. 8. Lift Setting: Position columns in bay using dimensions shown in Fig. 1a & Fig. 1b. Place column with power unit mounting bracket on vehicle passenger side of lift. Both column base plate backs must be square on center line of ...
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: