Transcription of Installation Manual - Compustar
{{id}} {{{paragraph}}}
Example: confidence
Installation Manual - Compustar
Installation Manual By Firstech LLC, Version: Applicable to the following remote start system: CM-900 Auto Only Starter Control Module This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions; (1) This device may not cause harmful interference. (2) This device may accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate this device. Table of Contents Introduction .. 3 Kit Contents .. 3 Installation Basics .. 4 Key Points to Consider Before Installation : .. 4 Remote Code Routine(s).
your meter to DC before testing for this wire. A. At rest, with the ignition off, the stator wire should test 0V DC. B. Turn the ignition to the run position. The stator wire should now test between 1 – 6V DC. C. Start the vehicle with the key. The stator wire should now test between 12 – …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: