Transcription of Installation / Setup Guide - ThunderMax
{{id}} {{{paragraph}}}
Example: confidence
Installation / Setup Guide - ThunderMax
#309-485 2004-2011 Dyna , 2010- 2013 XL sportster , 2008-2010 Rocker , 2009 CVO FXSTSSE2 , 2008-12 XR1200 Seri al # TM RM All Models - Oxygen S ensor Ins tallati on Tips Your ThunderMax kit includes robust Wide-Band oxygen sensors that report data from every cylinde r combustion event to the ThunderMax ECM for automatic air/fuel corrections. These sensors replace the factory supplied narrow-band sensors first used on 2006 Dyna and in most cases are direct bolt-in replacements (2004- 2005 Dyna models will require the addition of 18mm sensor bungs to the exhaust header pipes). Installation of the wide band sensors into most bung-equipped headpipes presents no clearance problems; however, some pipe brands may require exhaust pipe modifica tio n or sensor bung relocation for interfe rence-free Installation . The sensors must mount freely without contactin g surrounding components.
Step 2 - Module Installation – Sportster® (Skip ahead for other models) Remove any previously installed ancillary tuning device including oxygen sensor eliminators that may
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: