Transcription of INSTALLATION - Stemco
{{id}} {{{paragraph}}}
INSTALLATION . voyager and Discover Hub-Seal INSTALLATION Step 1 Remove all burrs from the hub bore and spindle. Thoroughly clean hub cavity and spindle. NOTE: Do not apply any sealant to the spindle 1. shoulder. Step 2 With the wheel in horizontal position, pre-lube the inner bearing and place it into the bearing cup. [Photo 1] NOTE: When using grease, pre-pack the inner bearing before placement into the hub. Step 3 Place the seal on the recommended Stemco INSTALLATION Tool, with the correct head, so that the words Air Side 2. face into the tool. Place the tool (with the seal correctly mounted in the tool head) over the hub bore. Use a 3 to 5 pound hammer to drive against the end of the tool. Drive seal into bore until complete bottoming is assured.
www.stemco.com 1-800-527-849 2 Voyager ® and Discover ® Hub-Seal Installation Step 1 Remove all burrs from the hub bore and spindle. …
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}