Transcription of Instructions for Removing and Replacing Cylinder of Entry ...
{{id}} {{{paragraph}}}
Example: air traffic controller
Instructions for Removing and Replacing Cylinder of Entry ...
For Inswinging DoorFor Outswinging DoorInsideOutsideInsideOutsideLeft HandRight Hand Left HandRight Hand124372 56341412 Keying Kit28739/013. Insert Cylinder Removing tool (2) edgewise between screw stem (5) and the detent slide (6) rotating tool clockwise to position shown. Apply slight leverage to remove spring tension while holding spindle downwards allowing spindle to drop out. If necessary use free thumb to assist removal. If spindle rotates, repeat step Insert Cylinder Removing tool in lock housing (7) pushing together Cylinder retaining springs by moving tool up and down and push Cylinder out of knob. If door not available, note position of Cylinder in knob for Replace round spindle by lining up boss (3) with slot (4) and push spindle until the detent spring snaps into Position Cylinder so that pin cover and key cuts are in the upward position (as shown in illustration).
Instructions for Removing and Replacing Cylinder of Entry Knob. WARNING: This Manufacturer advises that no lock can provide complete security by itself. This lock may be defeated by forcible or technical means, or evaded by entry elsewhere on the property. No lock can substitute for caution, awareness of your environment, and common sense.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Keys E D I U, Replacement Guide, Mechanism, Lock, Lock Mechanism Replacement Guide, Lock mechanism replacement, SHIFT INTERLOCK SYSTEM, Lock Mechanism, Guide, HOW CABINET LOCKS ARE USED, Replacement lock, Replacement, GENERAL DESCRIPTION 3 B.2, Ignition Switch & Lock Cylinder Replacement Instructions, INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR