Transcription of Intertherm 50 - AkzoNobel
{{id}} {{{paragraph}}}
Example: bachelor of science
Intertherm 50 - AkzoNobel
A single component, high temperature coating, based on a moisture curing silicone binder. The moisture curing crosslinking mechanism allows multiple coats to be applied without heat curing. Suitable for temperatures up to 540 C (1004 F). PRODUCT DESCRIPTIONFor the protection of steel from corrosion on areas including flare stacks, chimneys, exhausts, vents and pipework, at temperatures up to 540 C (1004 F). Where maximum corrosion protection is required, application should be over a zinc silicate primer ( Interzinc 22). INTENDED USESA luminium, Black Not applicable 45% 25 microns (1 mils) dry equivalent to 56 microns ( mils) wet18 m /litre at 25 microns and stated volume solids722 gallon at 1 mils and stated volume solids Allow appropriate loss factors Air Spray, Brush, RollerPRACTICAL INFORMATION FOR Intertherm 50 ColourGloss LevelVolume SolidsTypical ThicknessTheoretical CoveragePractical CoverageMethod of ApplicationDrying TimeTemperature Touch DryHard DryMinimumMaximum See International Protective Coatings Definitions and AbbreviationsOvercoating Interval withrecommended topcoats5 C (41 F) 90 minutes5 hours24 hours Extended 15 C (59 F) 60 minutes3 hours16 hours Extended 25 C (77 F) 30 minutes2 hours12 hours Extended 40 C (104 F) 15 minutes1 hour6 hours Extended 25 C (77 F) kg/l ( lb/gal)
Oct 30, 2017 · Hand or power tool clean to a minimum St3 (ISO 8501-1:2007) or SSPC-SP3. Note, all scale must be removed and areas which cannot be prepared adequately by chipping or needle gun should be spot blasted to a minimum standard of Sa2½ (ISO 8501-1:2007) or SSPC-SP6. Typically this would apply to C or D grade rusting in this standard. Primed Surfaces
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: