Transcription of Lathe Milling Attachment - Vintage Projects and …
{{id}} {{{paragraph}}}
Lathe Milling AttachmentBy L C. MASONM illing Attachment inuse on 7-in. Lathe formilling out parts inthe manifold of amodel 4-cylinder gasengine. One holdingclamp removed CLEVERLY stacking cold-rolled flat stocktogether, T-slots and slide for this lathemilling Attachment are made without costlymachinery. In fact, only two tools, a drill pressand Lathe , are needed to make the mounted on the cross slide of a Lathe (Fig. 1), the Attachment features a swivel baseand tilting slide which has T-slots for clampingthe work securely in place. Although this at-tachment was made for a 7-in. Atlas Lathe , theoverall dimensions could be increased 25% foruse with a 9 or 10-in by cutting the stock size cold-rolled flatstock for T-slot pieces A, B, C and D in Fig. 3to 3-in. lengths. Then lay out and drill the #21holes. Pieces A and B, and C and D can beclamped together when drilling so that they willline up properly when assembling later.
Lathe Milling Attachment By L C. MASON Milling attachment in use on 7-in. lathe for milling out parts in the manifold of a model 4-cylinder gas engine.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}