Transcription of LC-1 Digital Air/Fuel Ratio (Lambda) Sensor Controller Manual
{{id}} {{{paragraph}}}
Example: air traffic controller
LC-1 Digital Air/Fuel Ratio (Lambda) Sensor Controller Manual
Document # 11-0053 11-0053 LC-1 Digital Air/Fuel Ratio (Lambda) Sensor Controller Manual Warning! The Oxygen Sensor used in this device gets very hot in operation. Do not touch the hot Sensor . Do not let a hot Sensor touch a combustible surface. Do not use the Sensor with or near flammable liquids or gases. Failure to heed these warnings may result in severe burns, explosions or fires. When installed in the exhaust, the oxygen Sensor MUST be connected and operating with the LC-1 whenever the car is running. An un-powered oxygen Sensor will be quickly damaged when exposed to hot exhaust gases.
The sensor should be removed from the exhaust and in free air for both the heater and free air calibrations 3.1 Heater Calibration 1. Remove the sensor from the exhaust, the sensor needs to be in free air for this procedure. 2. Disconnected the sensor from the LC-1’s sensor connector. 3. Switch 12V supply to the LC-1 ON.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: