Low Power, 3.3 V, RS-232 Line Drivers/Receivers ADM3202 ...
The ADM3202/ADM3222/ADM1385 transceivers are high speed, 2-channel RS-232/V.28 interface devices that operate from a single 3.3 V power supply. Low power consumption and a shutdown facility (ADM3222/ADM1385) make them ideal for battery-powered portable instruments.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
AD743 Ultralow Noise BiFET Op Amp Data Sheet …
www.analog.comREV. E Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its
Devices, Noise, Ad743 ultralow noise bifet op amp, Ad743, Ultralow, Bifet, Analog devices, Analog
MT-070: In-Amp Input RFI Protection - Analog …
www.analog.comRev.0, 10/08, WK Page 1 of 6 MT-070 TUTORIAL In-Amp Input RFI Protection . PROTECTING IN-AMPS AGAINST RFI . Real-world applications must deal with an ever increasing amount of radio frequency
LTC3108 - Ultralow Voltage Step-Up Converter and …
www.analog.comLTC3108 3108fc For more information www.linear.com/LTC3108 LDO
1.8 V Low Power CMOS Rail-to-Rail Input/Output …
www.analog.com1.8 V Low Power CMOS Rail-to-Rail Input/Output Operational Amplifier Data Sheet AD8515 Rev. E Document Feedback Information furnished by Analog Devices is believed to be accurate and reliable.
Devices, Operational, Data, Input, Analog devices, Analog, Output, Cmos rail, Cmos, Rail, To rail, To rail input output operational amplifier data, Amplifier
Low Cost Micropower, Low Noise CMOS Rail-to …
www.analog.comLow Cost Micropower, Low Noise CMOS Rail-to-Rail, Input/Output Operational Amplifiers Data Sheet AD8613/AD8617/AD8619 Rev. H Document Feedback Information furnished by Analog Devices is believed to be accurate and reliable.
Devices, Operational, Sheet, Data, Input, Analog devices, Analog, Output, Cmos rail, Cmos, Rail, To rail, Amplifier, Micropower, Input output operational amplifiers data sheet ad8613, Ad8613
Low Cost CMOS, High Speed, Rail-to-Rail Amplifiers
www.analog.comLow Cost CMOS, High Speed, Rail-to-Rail Amplifiers Data Sheet ADA4891-1/ADA4891-2/ADA4891-3/ADA4891-4 Rev. F Document Feedback Information furnished by Analog Devices ...
Zero-Drift, Single-Supply, Rail-to-Rail Input/Output ...
www.analog.comZero-Drift, Single-Supply, Rail-to-Rail Input/Output Operational Amplifier Data Sheet AD8628/AD8629/AD8630 FEATURES Lowest auto-zero amplifier noise Low offset voltage: 1 µV AD8628
Operational, Data, Input, Output, Rail, To rail input output operational amplifier data, Amplifier, To rail input
FEATURES DESCRIPTIO U - analog.com
www.analog.com1 LT1025 1025fb DESCRIPTIO U APPLICATIO S U 80µA Supply Current 4V to 36V Operation 0.5°C Initial Accuracy (A Version) Compatible with Standard Thermocouples (E, J, K, R, S, T) Auxiliary 10mV/°C Output Available in 8-Lead PDIP and SO Packages Thermocouple Cold Junction Compensator Centigrade Thermometer Temperature …
LT1173 - Micropower DC/DC Converter Adjustable …
www.analog.comLT1173 1 Micropower DC/DC Converter Adjustable and Fixed 5V, 12V VOUT 5V/DIV 0V PROGRAM 5V/DIV 5ms/DIV 1173 TA02 L1* 100µH LT1173 • TA01 + GND SW2 FB SW1 ILIM VIN 10 F LT1173
AD9850 CMOS, 125 MHz Complete DDS …
www.analog.comrev. h a cmos, 125 mhz complete dds synthesizer ad9850 functional block diagram clock out clock out analog in analog out dac rset …
Complete, Analog, 125 mhz complete dds, 125 mhz complete dds synthesizer, Synthesizer
Related documents
CAN-Bus Troubleshooting Guide
www.esd-electronics-usa.comtransceivers. For a voltage lower than 2.0 V please check CAN_H and CAN_L conductors for continuity. For a voltage higher than 4.0 V, please check for excessive voltage. To find the node with a faulty transceiver please te st the CAN transceiver resistance (see next page). 1.3 Ground The shield of the CAN network has to be grounded at only one ...
LTC2870/LTC2871 – RS232/RS485 Multiprotocol Transceivers ...
www.analog.comVCC = VL = 3.3V, TE485 = 0V, LB = 0V unless otherwise noted. SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS Power Supply VCC Supply Voltage Operating Range 3 5.5 V VL Logic Supply Voltage Operating Range VL ≤ VCC 1.7 VCC V VCC Supply Current in Shutdown Mode RXEN = VL, DXEN = TE485 = FEN = 0V, (LTC2870) DX485 = DX232 = …
MAX3160/MAX3161/MAX3162 +3.0V to+5.5V, 1µA, RS-232/ …
datasheets.maximintegrated.comMAX3160/MAX3161/MAX3162 +3.0V to+5.5V, 1µA, RS-232/ RS-485/422 Multiprotocol Transceivers EVALUATION KIT AVAILABLE General Description The MAX3160/MAX3161/MAX3162 are …
D C a n d A C S w i t c h i n g C h a r a c t e r i s t i ...
www.xilinx.comI/O supply voltage for the high-bandwidth memory –0.300 1.500 V V. CCAUX_HBM. Auxiliary supply voltage for the high-bandwidth memory –0.300 3.000 V GTY or GTM Transceiver. 7. V. CCINT_GT. Digital supply voltage for select modules in the GTM transceivers –0.500 1.000 V V. MGTAVCC. Analog supply voltage for transceiver circuits –0.500 1 ...
SA612A Double-balanced mixer and oscillator
www.nxp.com3. Applications Cordless telephone Portable radio VHF transceivers RF data links Sonobuoys Communications receivers Broadband LANs HF and VHF frequency conversion Cellular radio mixer/oscillator SA612A Double-balanced mixer and oscillator Rev. 3 …
Balanced, Double, Transceiver, Mixers, Double balanced mixer
MAX3222/MAX3232/MAX3237/MAX3241 - 3.0V to 5.5V, Low …
datasheets.maximintegrated.comInput Voltage Range -25 25 V Input Threshold Low TA = +25°C VCC = 3.3V 0.6 1.2 V VCC = 5.0V 0.8 1.5 Input Threshold High TA = +25°C VCC = 3.3V 1.5 2.4 V VCC = 5.0V 1.8 2.4 Absolute Maximum Ratings Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and ...
Checking Port Status and Connectivity
www.cisco.comYou can have up to eight simultaneous Telnet sessions. Before you can open a Telnet sessio n to the switch, you must first set the IP address (and in some cases the default gateway) for the switch. For information about setting the IP address and default gateway, see Chapter 3, “Configuring the Switch for the First Time.”
Connectivity, Status, Ports, Checking, Checking port status and connectivity
3 A, Low V , Low Noise, CMOS Linear Regulator Data Sheet ...
www.analog.com1.6 V to 3.6 V 2 A Fixed/adjustable 16-lead LFCSP ADP1752/ ADP1753 1.6 V to 3.6 V 0.8 A Fixed/adjustable 16-lead LFCSP ADP1754/ ADP1755 1.6 V to 3.6 V 1.2 A Fixed/adjustable 16-lead LFCSP The ADP1763 is available in fixed output voltages ranging from 0.9 V to 1.5 V. The output of the adjustable output model can
Kintex-7 FPGAs Data Sheet: DC and AC Switching ... - Xilinx
www.xilinx.comKintex-7 FPGAs Data Sheet: DC and AC Switching Characteristics DS182 (v2.19) March 26, 2021 www.xilinx.com Product Specification 4 Table 3: DC Characteristics Over Recommended Operating Conditions Symbol Description Min Typ(1) Max Units VDRINT Data retention VCCINT voltage (below which configuration data might be lost) 0.75 – – V VDRI Data retention …