Transcription of Machining Guide for Engineering Plastics
{{id}} {{{paragraph}}}
Example: barber
Machining Guide for Engineering Plastics
Engineering PLASTIC PRODUCTSMACHINING INSTRUCTIONS FOR Engineering Plastics in association with:1 QUADRANT Engineering Plastic Products stock shapes can be easily machined on ordinarymetalworking and in some cases on woodworking machines. However, there are some points, which areworth noting to obtain improved view of the poor thermal conductivity, relatively low softening and melting temperatures ofthermoplastics,generated heat must be kept to a minimumand heat build up in the Plastics partavoided. This is in order to prevent deformations, stresses, colour changes or even melting.
Machining forces being lower for engineering plastics than for metals and the former deforming more easily if clamped too tightly, clamping pressures should be reduced. However, avoid any unsafe condition ... General industrial safety recommendations as well as eventual specific directions given in the Quadrant
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: