Transcription of Maintenance
{{id}} {{{paragraph}}}
Example: barber
Maintenance
22 MaintenanceTroubleshootingSYMPTOMPOSSIBL E CAUSESCORRECTIVE ACTIONPRESSURE WASHERWILL NOT RUNPump switch in OFF positionPlace switch in ON supply disconnectedConnect power blown or circuit breaker tripped in electrical supply lineReplace fuse or reset circuit breaker. Use only circuits of adequate circuit overload trippedAllow sufficient time for motor to cool down. Place pump switch in ON WASHERRUNS BUT WON'TSPRAYT rigger of trigger gun releasedSqueeze supply not turned onOpen water supply pressure nozzleClean pressure nozzle water screen cloggedCheck screen and clean if sucking airFill the detergent container and check for loose hose clamps or SPRAY PRESSURE ATNOZZLEI nadequate water supplyFully open faucet.
ignition control unit. B. Faulty ignition control unit 2. Touch one meter probe to the tip of the ignitor/ sensor rod in the pilot. Touch the other probe to the quick connect at the other end of ignitor/sensor wire. 3. If you have continuity from the tip of the ignitor/ sensor rod to the connector and no spark, replace the ignition control unit. 4.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: