Transcription of Manual of Standard Practice - CRSI
{{id}} {{{paragraph}}}
ContentsPreface iChapter 1 Material Specifications for Reinforcing Bars Introduction Reinforcing Bars ACI 318 Code Requirements for 1-1 Reinforcing Specialty Reinforcing Bars Spiral Reinforcement Standard Sizes Material Welding of Reinforcing Bars Material Specifications and Welding Code Project Drawings and Project Specifications CRSI Recommendations Identification Marks 1-5 ASTM Standard Reinforcing BarsChapter 2 Welded Wire Reinforcement (WWR) Introduction ASTM Specifications WWR Style Identification Specifying Welded Wire Reinforcement Detailing Welded Wire Reinforcement Width Length ASTM Specification for Epoxy-Coated Wire 2-2 and Welded Wire Reinforcement ASTM Specification for Zinc-Coated (Galvanized) 2-2 Steel Welded Wire ASTM Specification for Stainless-Steel 2-2 Welded Wire Rust Handling, Shipping and Unloading 2-3 Chapter 3 Supports for Reinforcement (Bar Supports) Introduction Side-Form Spacers Recommendations for Bar Supports Standard , Non-Coated Epoxy-Coated or Dual-Coated Galvanized Stainless-Steel Low-Carbon, Chromium Placing Bar Supports Application and Use of Bar Supports Slabs-on-Ground, Grade Beams 3-7 and Foundation Joist Construction Side-Form Spac
6.5.3 Correctly Using Concrete Cover when 6-12 Detailing 6.5.4 Lap Splices 6-12 6.5.5 Typical Bend Shapes, Measuring Points, 6-12 Fabrication Tolerances and Standard Hooks 6.5.5.1 Typical Bend Shapes, Measuring 6-12 Points and Fabrication Tolerances 6.5.5.2 Standard Hooks 6-13 6.5.6 Recommendations for Location of First 6-13 and Last Bar
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}