Transcription of MATERIAL SAFETY DATA SHEET - hp.com
{{id}} {{{paragraph}}}
MATERIAL SAFETY DATA SHEET SECTION 1 - IDENTIFICATION OF SUBSTANCE AND COMPANY Product Name: UV Discharge Lamp Chemical Name: Intact Sealed Article Manufacturer/Supplier: Primarc Phone: 610-829-4240 2 Danforth Drive Fax: 610-829-4260 Easton, PA 18045 Emergency Phone Numbers: Nordson Corporation 800-321-2881 Chemtrec 800-424-9300 SECTION 2 - INFORMATION ON COMPONENTS Hazardous and regulated components CAS Wt Component USA OSHA PEL UK WEL 14808-60-7 Quartz glass N/A N/A 7439-97-6 Up to 4g ( ave.) Mercury (Vapour) TLV mg/m3 IDLH 10 US Typical TLV / TWA mg/m3 Typical PEL mg/m3 1314-20-1 ~70mg Thorium Oxide 5 E-13 microcurie Th per ml air NO UK WEL 15552-14-4 ~70mg Barium Calcium Tungstate No Information Available NO UK WEL Additional components in specifically doped lamps: Gallium/Indium Doped Lamps: CAS Wt Component USA OSHA PEL UK WEL 7440-55-3 Up to 10mg Gallium TLV-TWA Not Established NO UK WEL 7440-74-6 Up to 3mg Indium TLV mg/m3 WEL Long term exposure limit (8hr TWA) is Short term exposure limit (15 minute) is m3 7774-29-0 Up to 20mg Mercury Iodide (HgI2) mg/m3 NO UK WEL Up to 15mg Gallium (II) Iodide (GaI2) No Information Available NO UK WEL 13450-91-4 Up to 10mg Gallium (III) Iodide (GaI3) No Information Available NO UK WEL 13510-35-5 Up to 5mg Indium (III) Iodide (InI3) TLV mg/m3 WEL Long term exposure limit (8hr TWA) is Short term exposure
MATERIAL SAFETY DATA SHEET F244.2.0608 Iron Doped Lamps: CAS Wt Component USA OSHA PEL UK WEL 7440-31-5 Up to 5mg Tin (Sn) 2 mg/m3 WEL Long term exposure limit (8hr TWA) is 2mg/m3
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
Icnirp guidelines, Radiation protection, Exposure to ultraviolet, PUPI TECHNICAL INFORMATION, TO ULTRAvIOLET RADIATION, Protection against, Protection, Radiation, Exposure, Evaluating school programmes, World Health, To ultraviolet, Determination of sun protection factor, Ultraviolet, SUNSCREENS: PREPARATION AND EVALUATION, EN 13758