Transcription of MCP25625 CAN Controller with Integrated Transceiver Data …
{{id}} {{{paragraph}}}
Example: air traffic controller
MCP25625 CAN Controller with Integrated Transceiver Data …
MCP25625 . CAN Controller with Integrated Transceiver General Features CAN Transceiver Features Stand-Alone CAN Controller with Integrated VDDA: to CAN Transceiver and Serial Peripheral Implements ISO-11898-2 and ISO-11898-5. Interface (SPI) Standard Physical Layer Requirements Up to 1 Mb/s Operation CAN Bus Pins are Disconnected when Device is Very Low Standby Current (10 A, typical) Unpowered: Up to 10 MHz SPI Clock Speed - An unpowered node or brown-out event will Interfaces Directly with Microcontrollers with not load the CAN bus to I/Os Detection of Ground Fault: Available in SSOP-28L and 6x6 QFN-28L - Permanent Dominant detection on TXD. Temperature Ranges: - Permanent Dominant detection on bus - Extended (E): -40 C to +125 C Power-on Reset and Voltage Brown-Out Protection on VDDA Pin CAN Controller Features Protection Against Damage Due to Short-Circuit Conditions (Positive or Negative Battery Voltage).
Aug 15, 2018 · TXD 16 24 CAN Transceiver I Transmit Data Input from CAN Controller NC 17 25 — — No Connection VSS 18 26 CAN Transceiver P Ground VDDA 19 27 CAN Transceiver P Power for CAN Transceiver RXD 10 28 CAN Transceiver O Receive Data Output to CAN Controller EP 29 — — — Exposed Thermal Pad Legend: P = Power, I = Input, O = Output, HV …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: