MCP25625 CAN Controller with ... - Microchip Technology

MCP25625 . CAN Controller with Integrated Transceiver General Features CAN Transceiver Features Stand-Alone CAN Controller with Integrated VDDA: to CAN Transceiver and Serial Peripheral Implements ISO-11898-2 and ISO-11898-5. Interface (SPI) Standard Physical Layer Requirements Up to 1 Mb/s Operation CAN Bus Pins are Disconnected when Device is Very Low Standby Current (10 A, typical) Unpowered: Up to 10 MHz SPI Clock Speed - An unpowered node or brown-out event will Interfaces Directly with Microcontrollers with not load the CAN bus to I/Os Detection of Ground Fault: Available in SSOP-28L and 6x6 QFN-28L - Permanent Dominant detection on TXD.

Aug 15, 2018 · Driver and Slope Control Thermal Protection POR UVLO Digital I/O Supply V IO V SS STBY Permanent Dominant Detect V IO V IO Mode Control Wake-up Filter CANH CANL CANH CANL Receiver LP_RX HS_RX SPI IF CAN Protocol Engine Tx Handler Tx Prioritization Control Logic Registers: Configuration, Control and Interrupts Rx Handler Acceptance Filters …

Loading..

Tags:

  Drivers, Handlers

Information