Transcription of Microsquirt Hardware Manual - EFI Source
{{id}} {{{paragraph}}}
Example: confidence
Microsquirt Hardware Manual - EFI Source
Microsquirt Hardware ManualMegasquirt-2 Product RangeMS2/Extra : 2015-03-14 Hardware Manual covering specific wiring and configuration of your Microsquirt version of the documentation applies to: Microsquirt V3 as shown above running firmware MS2/Extra not apply to other Megasquirt products or other firmware versions.(c) 2014 James MurrayMicrosquirt Hardware GuideTable of Chapters1 Microsquirt System Fuel Ignition System - Ignition system - specific operating Optional Example Further Appendix A Appendix B: Junkyard guide to finding Revision (c) 2014 James Murray2015-03-14 Page 2/ 154 Microsquirt Hardware GuideContents1 Emissions and Required How to use this Microsquirt System Microsquirt Wiring Harness and Crank / Cam Sensor Tuning Best Wire and connector Soldering or Re-pinning Making the Four-pin relay pin-out Relay and accessory power Grounding (Earthing) Core Wiring Relay Crank and Cam Tach MAP (Manifold Absolute Pressure) IAT/MAT (Intake/Manifold Air Temperature) CLT (Coolant Temperature) TPS (Throttle Position Sensor).
The Microsquirt is a compact ECU based on Megasquirt-2 technology. This manual covers Microsquirt specific installation details and should be used in conjunction with the general Setting up and TunerStudio reference manuals. 1.1 Emissions and disclaimer All parts are sold for OFF ROAD RACE-ONLY ground-vehicle use only, or vehicles that pre-date any
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: