Microsquirt Hardware Manual - EFI Source

Microsquirt Hardware ManualMegasquirt-2 Product RangeMS2/Extra : 2015-03-14 Hardware Manual covering specific wiring and configuration of your Microsquirt version of the documentation applies to: Microsquirt V3 as shown above running firmware MS2/Extra not apply to other Megasquirt products or other firmware versions.(c) 2014 James MurrayMicrosquirt Hardware GuideTable of Chapters1 Microsquirt System Fuel Ignition System - Ignition system - specific operating Optional Example Further Appendix A Appendix B: Junkyard guide to finding Revision (c) 2014 James Murray2015-03-14 Page 2/ 154 Microsquirt Hardware GuideContents1 Emissions and Required How to use this Microsquirt System Microsquirt Wiring Harness and Crank / Cam Sensor tuning Best Wire and connector Soldering or Re-pinning Making the Four-pin relay pin-out Relay and accessory power Grounding (Earthing) Core Wiring Relay Crank and Cam Tach MAP (Manifold Absolute Pressure) IAT/MAT (Intake/Manifold Air Temperature) CLT (Coolant Temperature) TPS (Throttle Position Sensor).

Microsquirt Hardware Guide This guide includes a number of notes which are indicated as follows: This symbol indicates an “Information” note. This symbol indicates a “Caution” note. This symbol indicates a “Warning” note. Installing or tuning your Microsquirt incorrectly can potentially cause damage to your engine, the Microsquirt or

Loading..

Tags:

  Guide, Manual, Hardware, Tuning, Microsquirt hardware manual, Microsquirt

Information