Transcription of Microsquirt Hardware Manual - EFI Source
{{id}} {{{paragraph}}}
Example: air traffic controller
Microsquirt Hardware Manual - EFI Source
Microsquirt Hardware ManualMegasquirt-2 Product RangeMS2/Extra : 2015-03-14 Hardware Manual covering specific wiring and configuration of your Microsquirt version of the documentation applies to: Microsquirt V3 as shown above running firmware MS2/Extra not apply to other Megasquirt products or other firmware versions.(c) 2014 James MurrayMicrosquirt Hardware GuideTable of Chapters1 Microsquirt System Fuel Ignition System - Ignition system - specific operating Optional Example Further Appendix A Appendix B: Junkyard guide to finding Revision (c) 2014 James Murray2015-03-14 Page 2/ 154 Microsquirt Hardware GuideContents1 Emissions and Required How to use this Microsquirt System Microsquirt Wiring Harness and Crank / Cam Sensor Tuning Best Wire and connector Soldering or Re-pinning Making the Four-pin relay pin-out Relay and accessory power Grounding (Earthing) Core Wiring Relay Crank and Cam Tach MAP (Manifold Absolute Pressure) IAT/MAT (Intake/Manifold Air Temperature) CLT (Coolant Temperature) TPS (Throttle Position Sensor).
Power probe 1.3 How to use this manual Customers new to EFI are advised to read all of sections 1-5 as these cover some fundamental concepts and give an overview of how to connect up the various EFI components. More experienced customers can likely skim through sections 1-5. Section 3.3 is the external wiring diagram, you should print that out.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: