Transcription of MIFARE type identification procedure - NXP
{{id}} {{{paragraph}}}
Example: quiz answers
MIFARE type identification procedure - NXP
AN10833 MIFARE type identification procedureRev. 10 August 2021 Application noteCOMPANY PUBLICD ocument informationInformationContentKeywordsMIF ARE, NTAG, ISO/IEC 14443 AbstractThis document describes how to differentiate between the members of theMIFARE card IC family. ISO/IEC 14443-3 describes the initialization and anti-collision procedure , and ISO/IEC 14443-4 describes the protocol activationprocedure. This document shows how to use these procedures to deliver thechip type information for all MIFARE ICs and SemiconductorsAN10833 MIFARE type identification procedureRevision Addition of newest generation General restructuring with focus on the GetVersion for MIFARE Plus for multi- MIFARE implementation and implementation in for MIFARE Implementation in a for for the new MIFARE Classic with 7 byte UID of Table 12320090518 Third release(supersedes AN MIFARE Interface Platform, Type identification procedure , Rev.)
identification. For MIFARE DESFire EV3 and MIFARE Plus EV2, the ATQA and SAK is configurable, so any ISO-conformal values are possible, therefore this cannot be used for type identification anymore. 2.2 Using the ISO activation parameters - not recommended! Note: It is not recommended to use the ISO activation parameters for type identification.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: