Transcription of MPC5121e Serial Peripheral Interface (SPI)
{{id}} {{{paragraph}}}
Example: biology
MPC5121e Serial Peripheral Interface (SPI)
Freescale SemiconductorApplication NoteDocument Number: AN3904 Rev. 0, 08/2009 Contents Freescale Semiconductor, Inc., 2009. All rights purpose of this application note is to describe the Serial Peripheral Interface bus controller (SPI) implemented on Freescale s MPC5121e microcontroller. It describes how to configure and use the programmable Serial controller (PSC) and PSC centralized FIFO controller (FIFOC) in all supported SPI objective of this application note is to describe the necessary steps needed to initialize and configure PSC in the SPI mode at all supported of the SPIThe Serial Peripheral Interface (SPI) protocol is asynchronous Serial data standard, primarily used to allow a microprocessor to communicate with other microprocessors or ICs such as memories, liquid crystal 1 Introduction.
MPC5121e Serial Peripheral Interface (SPI), Rev. 0 Description of the SPI module 2 Freescale Semiconductor diodes (LCD), analog-to-digital converter subsystems, etc. The SPI is a very simple synchronous serial data, master/slave protocol based on four lines:
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: