Transcription of Multipathing Configuration for Software iSCSI Using Port ...
{{id}} {{{paragraph}}}
Multipathing Configuration for Software iSCSI Using Port BindingTechnical WhiTe PaPeRMultipathing Configuration for Software iSCSI Using Port BindingTechnical WhiTe PaPeR / 2 Table of contentsMultipathing for Software iSCSI ..3 Configuring vmknic-Based iSCSI Multipathing ..3a) Configuring the Network ..31. Using GUI ..32. Using CLI ..6b) Enabling the iSCSI Software Adapter ..71. Using GUI ..72. Using CLI ..9c) Activating vmknic-Based Multipathing for Software iSCSI ..91. Configuring Port Binding on vSphere Using GUI ..92. Configuring Port Binding on vSphere Using CLI.
Multipathing Configuration for Software iSCSI Using Port Binding 2. Using CLI Run the following commands: 1) Enable the software iSCSI: esxcfg-swiscsi –e 2) To change the default iSCSI initiator name, set the initiator iqn: - esxcli iscsi adapter set --name iqn.1998-01.com.vmware:esx-host01-64ceae7s -A vmhbaXX
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}