Transcription of MX-100 SERIES MIXING STATIONS - KnightEquip.com
{{id}} {{{paragraph}}}
Example: quiz answers
MX-100 SERIES MIXING STATIONS - KnightEquip.com
Page 1 of 6 0900936 Rev C 05/01 ,167$//$7,21 MOUNTING THE UNIT (1) Choose a convenient location close to water supply and not more than 5 off floor. (2) Remove the cover from the unit. (3) Hold proportioner against wall and mark keyholes use a level for marking holes. (4) Drill holes and install either toggle bolts or masonry screws (not supplied). (5) Hang the unit and tighten screws see Figures 1 and 2. Always refer to hardware manufacturer s specifications for weight capacity and usage. ATTACHING THE DRIP TRAY (OPTIONAL) (1) Locate tray 12 to 15 below spouts. Mount in the same manner as proportioner. (2) Attach a length of 1/4" tubing to drip tray for draining liquids. (3) Divert drain tube to sink, drain, or five gallon holding jug.
0900936 Rev C 05/01 Page 3 of 6 These charts are based upon the chemical viscosity of water (CPS = 1.0) and should only be used as a guide. Actual ratios
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Laboratory Ventilation, Rates, Ventilation, Dilution Ventilation, Pb metallic stearates pdf, Dilution, Flow Dilution Tunnel for Transient Test, Dilution techniques to improve quantitative, THE IMPORTANCE OF DILUTION FACTOR FOR, Measurement Using the Dye Dilution Technique, Kem Canada Mfg, 5210 BIOCHEMICAL OXYGEN DEMAND (BOD)* 5210, New Ventilation Guidelines For Health-Care