Transcription of NI 6003 Device Specifications - National Instruments
{{id}} {{{paragraph}}}
SPECIFICATIONSNI USB-6003 Low-Cost DAQ USB DeviceThe following Specifications are typical at 25 C, unless otherwise noted. For moreinformation about the NI USB-6003, refer to the NI USB-6001/6002/6003 User Guideavailable at InputNumber of sample rate (aggregate)100 typeSuccessive FIFO2,047 sourcesSoftware, PFI 0, PFI range 10 voltage 10 VOvervoltage 30 20 impedance>1 G ..Input bias current 200 pAAbsolute at full scale6 over temperature,full scale26 , no missing dB (DC to 5 kHz)..Bandwidth300 kHzAnalog range 10 update rate5 kS/s simultaneous per channel, FIFO2,047 sourcesSoftware, PFI 0, PFI current drive 5 circuit current 11 rate3 V/ 2 | | NI USB-6003 SpecificationsAbsolute accuracy (no load).
Caution Do not leave a voltage above 3.3 V connected on any DIO line for extended periods of time when the device is powered off. This may lead to long term ... Screw-terminal wiring 1.31 to 0.08 mm2 (16 to 28 AWG).....Torque for screw terminals 0.22 - 0.25 N · m (2.0 - 2.2 lb. · in.) If you need to clean the module, wipe it with a dry towel. ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}