NI 6259 Device Specifications - National Instruments
Timing resolution 50 ns Timing accuracy 50 ppm of sample rate Input coupling DC Input range ±0.1 V, ±0.2 V, ±0.5 V, ±1 V, ±2 V, ±5 V, ±10 V Maximum working voltage for analog inputs (signal + common mode) ±11 V of AI GND CMRR (DC to 60 Hz) 100 dB Input impedance Device on AI+ to AI GND >10 GΩ in parallel with 100 pF
Tags:
Devices, Specification, Timing, Device specifications
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
NI cDAQ -9191
www.ni.comDigital output sample clock frequency Streaming from application memory System-dependent Regeneration from FIFO 0 MHz to 10 MHz Finite 0 MHz to 10 MHz
Using Acoustic Beamforming for Pass-By Noise …
www.ni.comUsing Acoustic Beamforming . for Pass-By Noise Source Detection . NATIONAL INSTRUMENTS. APPLICATION NOTES. Abstract. This application note discusses a technique known as beamforming for determining noise location of passing
Using, National, Instruments, Acoustic, Using acoustic beamforming for pass by, Beamforming, Pass, Using acoustic beamforming, For pass by, National instruments
GETTING STARTED GUIDE to ±10 V, 16 Bit, 250 …
www.ni.comMeasurement Category I is for measurements performed on circuits not directly connected to the electrical distribution system referred to as MAINS voltage.
Guide, Electrical, Measurement, Getting, Started, Getting started guide to
NI 6509 User Guide and Specifications - National …
www.ni.comUSER GUIDE AND SPECIFICATIONS NI 6509 This document contains information about using the NI PCI-6509, NI PXI-6509, and NI PCIe-6509 data acquisition devices with the
Guide, User, Specification, National, User guide and specifications
NI 6528/6529 User Guide and Specifications - …
www.ni.comNI 6528/6529 User Guide and Specifications 6 ni.com Operate the DIO device only at or below Pollution Degree 2. Pollution is foreign matter in a solid, liquid, or gaseous state that can reduce dielectric
Guide, States, User, Specification, Solid, User guide and specifications
PXIe-5820 Getting Started Guide - National …
www.ni.comElectromagnetic Compatibility Guidelines This product was tested and complies with the regulatory requirements and limits for electromagnetic compatibility (EMC) stated in the product specifications.
Guide, Product, National, Getting, Started, Getting started guide
DEVICE SPECIFICATIONS NI 6722/6723
www.ni.comDEVICE SPECIFICATIONS NI 6722/6723 This document lists the specifications for the NI 6722/6723 analog output devices. The following specifications are typical at 25°C unless otherwise noted.
Devices, Specification, Device specifications ni 6722 6723, 6722, 6723
NI cRIO-9030 Specifications - National Instruments
www.ni.comSPECIFICATIONS NI cRIO-9030 Embedded CompactRIO Controller with Real-Time Processor and Reconfigurable FPGA This document lists the specifications for the National Instruments cRIO-9030.
NI PS-15 Power Supply User Manual and …
www.ni.com©National Instruments Corporation viii NI PS-15 Power Supply User Manual About This Manual The NI PS-15 Power Supply User Manual describes the features and specifications of the NI PS-15 power supply and contains information
Manual, Power, Supply, National, Instruments, National instruments, Ps 15 power supply
NI PXIe-1435 User Guide and Specifications - …
www.ni.comNI PXIe-1435 User Guide and Specifications The NI PXIe-1435 (NI 1435) is a PXI Express (PXIe) image acquisition device that supports Base, Medium, Full, and Extended Full configuration Camera Link cameras and supports Power over Camera
Guide, User, Specification, 5413, 1435 user guide and specifications
Related documents
ESP32C3 Family
www.mouser.com• A Bluetooth LE subsystem that supports features ... 16 Frequency 30 17 TX Power with Spectral Mask and EVM Meeting 802.11 Standards 30 18 TX EVM Test 30 ... 5 ESP32-C3 Family Power-up and Reset Timing 12 6 Setup and Hold Times for the Strapping Pin 13 7 Address Mapping Structure 16 8 QFN32 (5×5 mm) Package 36 ...
LPC546xx Product data sheet
www.nxp.comWatchdog Oscillator (WDTOSC) with a frequency range of 6 kHz to 1.5 MHz. 32.768 kHz low-power RTC oscillator. System PLL allows CPU operation up to the maximum CPU rate and can run from the main oscillator, the internal FRO, the watchdog oscillator or the 32.768 KHz RTC oscillator. Two additional PLLs for USB clock and audio subsystem.
ADRV9026 System Development User Guide (Rev. PrA)
www.analog.comThe ADRV9026 is designed to operate over the wide frequency ranges of 650 MHz to 6 GHz. The receiver channels support bandwidth up to 200 MHz with data transfer across (up to) four JESD204B/JESD204C lanes at rates up to 16.22 Gbps. The transmitter channels operate over the same frequency range as the receivers.
Integrated, Dual RF Transceiver with Observation Path Data ...
www.analog.comCenter Frequency 300 6000 MHz Tx Large Signal Bandwidth (BW) 100 MHz Tx Synthesis BW2 250 MHz Wider bandwidth for use in digital processing algorithms BW Flatness ±0.5 dB 250 MHz BW, compensated by programmable finite infinite response (FIR) filter ±0.15 dB Any 20 MHz BW span, compensated by programmable FIR filter
Understanding and Performing MIPI D-PHY Physical Layer ...
download.tek.comfrequency will not alter the signal rise time or fall time for both the speed of operations. The measurement algorithm is capable of tolerating the Glitch as shown in Figure 4 when you operate in the broadcast mode and are still able to perform the measurement by selectively qualifying the HS entry mode. Figure 4. Pinpoint triggering.
DC TO DC CONVERTER CONTROLLER
atta.szlcsc.comThe MC34063 is a monolithic regulator subsystem, intended for use as DC to DC converter. This device contains a temperature compensated band gap reference, a duty-cycle control oscillator, driver and high current output switch. It can be used for step down, step-up or inverting switching regulators as well as for series pass regulators. FEATURES
MPC5748G, MPC5748G Microcontroller Data Sheet
www.nxp.com– 96 Configurable Enhanced Modular Input Output Subsystem (eMIOS) channels • Device/board boundary Scan testing supported with per Joint Test Action Group (JTAG) of IEEE (IEEE 1149.1) and 1149.7 (cJTAG) • Security – Hardware Security Module (HSMv2)