Non-licensed tasks What this sheet covers
Never clean inside the vacuum cleaner yourself. Never attempt to remove or change the bag yourself; this should be done by a competent person under controlled conditions. Contact the supplier or a licensed organisation for assistance. After each use, clean the vacuum cleaner’s outer casing and attachments with the vacuum and then with damp rags.
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
INDG422 - Thorough examination of lifting equipment
www.hse.gov.ukHealth and Safety Executive inspection under PUWER will be limited to the non-lifting parts such as the brakes, lights, and fall-over protection; the maintenance of both the lifting and non-lifting parts of the truck will be
The Crop Definitions List - Health and Safety …
www.hse.gov.ukRevised November 2017 1 The Crop Definitions List The Crop Definitions List replaces the Crop Hierarchy. It provides consistent terminology for the …
Definition, Lists, Corps, The crop definitions list, The crop definitions list the crop definitions list
Examples of good practice identified during KP3 …
www.hse.gov.ukExamples of good practice identified during KP3 inspections This list of Good Practices has been derived from KP3 Inspection reports. Companies might regard some of the examples as normal practice.
Good, Practices, Example, During, Inspection, Examples of good practice identified during kp3, Identified, Examples of good practice identified during kp3 inspections
Health and safety regulation a short guide HSC13
www.hse.gov.ukHealth and Safety Executive How regulations apply Some regulations apply across all companies, such as the Manual Handling Regulations which apply wherever things are moved by hand or bodily force, and
Pressure systems at work: A brief guide to safety …
www.hse.gov.ukPage 1 of 5 Health and Safety Executive Pressure systems A brief guide to safety Introduction If pressure equipment fails in use, it can …
Radiation protection supervisors
www.hse.gov.ukIntroduction This HSE information sheet is aimed at radiation employers, radiation protection advisers (RPA), radiation protection supervisors (RPS), safety representatives and
Protection, Supervisor, Radiation, Radiation protection supervisors
Health and Safety Executive The SACGM …
www.hse.gov.ukHeading/title Health and Safety Executive The SACGM Compendium of guidance Part 3: Containment and control of activities involving
Safety, Executive, Safety executive the sacgm, Sacgm, Safety executive the sacgm compendium of, Compendium
Working aloneHealth and safety guidance on the …
www.hse.gov.ukHealth and Safety Executive Working alone: Health and safety guidance on the risks of lone working Page 2 of 5 As mobile workers working away from their fixed base
Introduction What is hand-arm vibration?
www.hse.gov.ukPage 1 of 6 Health and Safety Executive Hand-arm vibration at work A brief guide Introduction This leaflet explains what you, as an employer, may …
HSES LAND USE PLANNING METHODOLOGY - …
www.hse.gov.ukHSES LAND USE PLANNING METHODOLOGY. Contents . Introduction. ackground to HSEs involvement in land use planning. The principles behind HSEs land use planning methodology
Related documents
Dow Corning High-Vacuum Grease Product Information
www.duniway.comDow Corning High-Vacuum Grease is recommended for vacuums reaching between 1 x 10-5 and 1 x 10-6 mm Hg. It is recommended that the grease be preconditioned under vacuum and temperature until these limits are reached. For details on attaining higher vacuums, please contact Dow Corning Customer Service at 1-800-248-2481. LISTINGS/SPECIFICATIONS
Special Coverage Adjustment N182202780 Brake Assist ...
static.nhtsa.govcoverage and inform the customer that the repair will need to be covered under warranty, customer pay, or goodwill. • If low vacuum is found, and the root cause is traced back to the vacuum pump via the diagnostics in Brake System Vacuum Source Test in SI, proceed to step 2. 2. Replace the vacuum pump and vacuum pump belt.
Vacuum Pumps Common Problems and Troubleshooting
torr-engenharia.com.brAfter Switching off Pump under Vacuum, Pressure in System Rises too Fast o System has a leak and should be checked o Malfunctioning of the anti-suck back valve – Repair the valve. Vacuum Boosters Knocking or Rapping o Unit out of time due to …
Designing a Robotic Vacuum Cleaner Report - Project Group 16
portfolio.id.utwente.nlThere are many different companies that develop robotic vacuum cleaners. In the appendix under ‘A. Market Analysis’ there is more detailed information about the main competitors. In the following the conclusion of the market analysis are presented. Difference between ‘traditional’ vacuum cleaners and vacuum cleaning robots
USER'S GUIDE 12B1, 1240, 68C7 SERIES
bissellcdn.blob.core.windows.netunder the red power switch on the bottom left of the back of the vacuum. Press the black handle release pedal with foot to place vacuum into one of three cleaning positions: 1. Upright: for storage, transporting, and above floor cleaning with tools. • Transport in upright position by tilting vacuum on rear wheels and push
nXDS Scroll Pump - Ideal Vacuum
www.idealvac.comdeclare under our sole responsibility, as manufacturer and person within the EU authorised to assemble the technical file, that the product(s) nXDS6i scroll pump 100-127 VAC, 200-240 VAC, 50/60 Hz A735-01-983
Understanding Vacuum and Vacuum Measurement
solarmfg.comHigh Vacuum – is vacuum where the MFP of residual gasses is longer than the size of the chamber or of the object under test. High vacuum usually requires multi-stage pumping and ion gauge measurement. NASA has revealed that the vacuum level recorded on the moon was 1x10-9 Torr. 1 Ultra-High vacuum – requires baking the chamber to
Vacuum Pump Maintenance and Troubleshooting
www.millrocktech.comvacuum pump under a hood to capture the exhausted solvents. Once the solvents have left the product the pressure in the system will start to go back down and the vacuum pump gas ballast should be closed. Care Should Be Taken to NOT Leave a Gas Ballast Open In normal operation of a vacuum pump the gas ballast remains closed.